From 2b8dca5dbf3853a5f069a8c4b5551665b91e37c3 Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Fri, 31 May 2019 13:47:15 -0400 Subject: probe: Move multi-sampling capability from ProbePointsHelper to Probe This changes the config file so that the configuration of multi-samples is now done in the [probe] (and [bltouch]) section instead of the various delta, bed_mesh, z_tilt, etc. config sections. With this change, PROBE and PROBE_CALIBRATE commands now also utilize multi-sampling. Signed-off-by: Kevin O'Connor --- test/klippy/screws_tilt_adjust.cfg | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'test') diff --git a/test/klippy/screws_tilt_adjust.cfg b/test/klippy/screws_tilt_adjust.cfg index 7b29e6ec..cc985d19 100644 --- a/test/klippy/screws_tilt_adjust.cfg +++ b/test/klippy/screws_tilt_adjust.cfg @@ -56,6 +56,9 @@ max_temp: 130 sensor_pin: ar30 control_pin: ar32 z_offset: 1.15 +samples: 3 +sample_retract_dist: 2. +samples_result: median [bed_mesh] min_point: 10,10 @@ -83,7 +86,4 @@ screw4: 10,190 screw4_name: read left screw horizontal_move_z: 10. speed: 50. -samples: 3 -sample_retract_dist: 2. -samples_result: median screw_thread: CW-M3 -- cgit v1.2.3-70-g09d2