From a301713361f7c2a1b397697b09dacab18ffdc05c Mon Sep 17 00:00:00 2001 From: Michael Barbour Date: Sun, 1 Apr 2018 15:26:25 -0400 Subject: extruder: Add SET_PRESSURE_ADVANCE command. Signed-off-by: Michael Barbour --- docs/G-Codes.md | 3 +++ 1 file changed, 3 insertions(+) (limited to 'docs') diff --git a/docs/G-Codes.md b/docs/G-Codes.md index d4586b71..37a72717 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -71,6 +71,9 @@ The following standard commands are supported: cycles. If the WRITE_FILE parameter is enabled, then the file /tmp/heattest.txt will be created with a log of all temperature samples taken during the test. +- `SET_PRESSURE_ADVANCE [ADVANCE=] + [ADVANCE_LOOKAHEAD_TIME=]`: + Set pressure advance parameters. - `RESTART`: This will cause the host software to reload its config and perform an internal reset. This command will not clear error state from the micro-controller (see FIRMWARE_RESTART) nor will it -- cgit v1.2.3-70-g09d2