From 1b471b482d4cc0a7b2779220d6a88f7736b34f3e Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Sat, 17 Oct 2020 19:36:45 -0400 Subject: docs: Note PROBE_CALIBRATE results invalidated on motion system update Any hardware change to the hotend or probe, change to the kinematics, or change to the bed tilt is likely to invalidate the results of PROBE_CALIBRATE. Try to warn the user of that. Signed-off-by: Kevin O'Connor --- docs/Manual_Level.md | 6 ++++++ 1 file changed, 6 insertions(+) (limited to 'docs/Manual_Level.md') diff --git a/docs/Manual_Level.md b/docs/Manual_Level.md index 38327c97..3ae75447 100644 --- a/docs/Manual_Level.md +++ b/docs/Manual_Level.md @@ -185,3 +185,9 @@ This means that: Repeat the process several times until you get a good level bed - normally when all adjustments are below 6 minutes. + +If using a probe that is mounted on the side of the hotend (that is, +it has an X or Y offset) then note that adjusting the bed tilt will +invalidate any previous probe calibration that was performed with a +tilted bed. Be sure to run [probe calibration](Probe_Calibrate.md) +after the bed screws have been adjusted. -- cgit v1.2.3-70-g09d2