From babc9e7a1e2d6a8dc7a826ff66c0a11b8a1e556a Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Thu, 1 Dec 2016 10:21:36 -0500 Subject: docs: Minor updates to wording of some documents Signed-off-by: Kevin O'Connor --- docs/Installation.md | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-) (limited to 'docs/Installation.md') diff --git a/docs/Installation.md b/docs/Installation.md index 6a2447cc..f5d8529b 100644 --- a/docs/Installation.md +++ b/docs/Installation.md @@ -1,8 +1,7 @@ Klipper is currently in an experimental state. These instructions assume the software will run on a Raspberry Pi computer in conjunction -with OctoPrint. Klipper supports only Atmel ATmega based -micro-controllers and Arduino Due (Atmel SAM3x8e ARM -micro-controllers) printers at this time. +with OctoPrint. Klipper supports Atmel ATmega based micro-controllers +and Arduino Due (Atmel SAM3x8e ARM micro-controllers) printers. It is recommended that a Raspberry Pi 2 or Raspberry Pi 3 computer be used as the host. The software will run on a first generation -- cgit v1.2.3-70-g09d2