From a238ec6f98e78af9d398c68b74d73f3254e0cbf3 Mon Sep 17 00:00:00 2001 From: Arksine Date: Tue, 21 May 2019 20:47:33 -0400 Subject: idle_timeout: Add SET_IDLE_TIMEOUT gcode Signed-off-by: Eric Callahan --- docs/G-Codes.md | 2 ++ 1 file changed, 2 insertions(+) (limited to 'docs/G-Codes.md') diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 6f895e52..3c885677 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -160,6 +160,8 @@ The following standard commands are supported: for calibrating a Z position_endstop config setting. See the MANUAL_PROBE command for details on the parameters and the additional commands available while the tool is active. +- `SET_IDLE_TIMEOUT [TIMEOUT=]`: Allows the user to set the + idle timeout (in seconds). - `RESTART`: This will cause the host software to reload its config and perform an internal reset. This command will not clear error state from the micro-controller (see FIRMWARE_RESTART) nor will it -- cgit v1.2.3-70-g09d2