From 15b5dbaf8ffac8e3889b2cc0ba7a61bce1e9fb6f Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Mon, 16 Nov 2020 18:47:32 -0500 Subject: docs: Move config reference information to new Config_Reference.md Move all the config reference information from files in the config/ directory to a new Config_Reference.md document. Signed-off-by: Kevin O'Connor --- docs/Endstop_Phase.md | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-) (limited to 'docs/Endstop_Phase.md') diff --git a/docs/Endstop_Phase.md b/docs/Endstop_Phase.md index f9944857..ec9ee68e 100644 --- a/docs/Endstop_Phase.md +++ b/docs/Endstop_Phase.md @@ -105,8 +105,8 @@ Additional notes enable this feature be sure the G-Code slicer is configured with a layer height that is a multiple of a "full step", manually enable the endstop_align_zero option in the endstop_phase config section - (see config/example-extras.cfg for further details), and then - re-level the bed screws. + (see [config reference](Config_Reference.md#endstop_phase) for + further details), and then re-level the bed screws. * It is possible to use this system with traditional (non-Trinamic) stepper motor drivers. However, doing this requires making sure that @@ -122,4 +122,5 @@ Additional notes power reset, which would arrange for both the micro-controller and stepper motor drivers to be reset together. If using this mechanism, one would then need to manually configure the "endstop_phase" config - sections (see config/example-extras.cfg for the details). + sections (see [config reference](Config_Reference.md#endstop_phase) + for the details). -- cgit v1.2.3-70-g09d2