From 57e6acbc5c0d479786e924d588b51b3bb34da92a Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Wed, 6 Feb 2019 18:49:11 -0500 Subject: docs: Add Bed_Level.md and Probe_Calibrate.md documents Signed-off-by: Kevin O'Connor --- docs/Config_checks.md | 17 +++++++---------- 1 file changed, 7 insertions(+), 10 deletions(-) (limited to 'docs/Config_checks.md') diff --git a/docs/Config_checks.md b/docs/Config_checks.md index 69c30462..fb7cd852 100644 --- a/docs/Config_checks.md +++ b/docs/Config_checks.md @@ -152,16 +152,13 @@ command is: `PID_CALIBRATE HEATER=heater_bed TARGET=60` ### Next steps This guide is intended to help with basic verification of pin settings -in the Klipper configuration file. It may be necessary to perform -detailed printer calibration - a number of guides are available online -to help with this (for example, do a web search for "3d printer -calibration"). - -See the [Slicers](Slicers.md) document for information on configuring -a slicer with Klipper. If one is using traditional endstop switches -with Trinamic stepper motor drivers then see the -[Endstop Phase](Endstop_Phase.md) document. If using a delta printer, -see the [Delta Calibrate](Delta_Calibrate.md) document. +in the Klipper configuration file. Be sure to read the +[bed leveling](Bed_Level.md) guide. Also see the [Slicers](Slicers.md) +document for information on configuring a slicer with Klipper. After one has verified that basic printing works, it is a good idea to consider calibrating [pressure advance](Pressure_Advance.md). + +It may be necessary to perform other types of detailed printer +calibration - a number of guides are available online to help with +this (for example, do a web search for "3d printer calibration"). -- cgit v1.2.3-70-g09d2