From a1af78cb83eb91c20126d02012ad8a20405470b4 Mon Sep 17 00:00:00 2001 From: Yifei Ding Date: Sat, 20 Nov 2021 23:23:56 -0800 Subject: docs: Rename Documents Signed-off-by: Yifei Ding --- docs/Config_Reference.md | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'docs/Config_Reference.md') diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index ca601db3..e151dbcf 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -1112,8 +1112,8 @@ Printer Skew Correction. It is possible to use software to correct printer skew across 3 planes, xy, xz, yz. This is done by printing a calibration model along a plane and measuring three lengths. Due to the nature of skew correction these lengths are set via gcode. See -[skew correction](skew_correction.md) and -[command reference](G-Codes.md#skew-correction) for details. +[Skew Correction](Skew_Correction.md) and +[Command Reference](G-Codes.md#skew-correction) for details. ``` [skew_correction] @@ -3727,7 +3727,7 @@ TSLl401CL Based Filament Width Sensor. See the ### [hall_filament_width_sensor] Hall filament width sensor (see -[Hall Filament Width Sensor](HallFilamentWidthSensor.md)). +[Hall Filament Width Sensor](Hall_Filament_Width_Sensor.md)). ``` [hall_filament_width_sensor] @@ -3870,7 +3870,7 @@ vssa_pin: ### [replicape] -Replicape support - see the [beaglebone guide](beaglebone.md) and the +Replicape support - see the [beaglebone guide](Beaglebone.md) and the [generic-replicape.cfg](../config/generic-replicape.cfg) file for an example. -- cgit v1.2.3-70-g09d2