From 4f3a7fd227ce89dfffdd2b7fc205db410b9a24d5 Mon Sep 17 00:00:00 2001 From: yochiwarez Date: Tue, 22 Oct 2024 21:48:07 +0100 Subject: axis_twist_compensation: Implement Y-axis support This commit implements support for the Y-axis in the axis_twist_compensation module. This update enables the module to handle corrections for printers with a twisted Y rail. Signed-off-by: Jorge Apaza Merma --- docs/Config_Reference.md | 19 ++++++++++++++++++- 1 file changed, 18 insertions(+), 1 deletion(-) (limited to 'docs/Config_Reference.md') diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index 17b466b3..cb40991d 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -2083,7 +2083,7 @@ sensor_type: ldc1612 ### [axis_twist_compensation] -A tool to compensate for inaccurate probe readings due to twist in X gantry. See +A tool to compensate for inaccurate probe readings due to twist in X or Y gantry. See the [Axis Twist Compensation Guide](Axis_Twist_Compensation.md) for more detailed information regarding symptoms, configuration and setup. @@ -2108,6 +2108,23 @@ calibrate_y: 112.5 # This should be the Y coordinate that positions the nozzle during the # calibration process. This parameter must be provided and is recommended to # be near the center of the bed + +# For Y-axis twist compensation, specify the following parameters: +calibrate_start_y: ... +# Defines the minimum Y coordinate of the calibration +# This should be the Y coordinate that positions the nozzle at the starting +# calibration position for the Y axis. This parameter must be provided if +# compensating for Y axis twist. +calibrate_end_y: ... +# Defines the maximum Y coordinate of the calibration +# This should be the Y coordinate that positions the nozzle at the ending +# calibration position for the Y axis. This parameter must be provided if +# compensating for Y axis twist. +calibrate_x: ... +# Defines the X coordinate of the calibration for Y axis twist compensation +# This should be the X coordinate that positions the nozzle during the +# calibration process for Y axis twist compensation. This parameter must be +# provided and is recommended to be near the center of the bed. ``` ## Additional stepper motors and extruders -- cgit v1.2.3-70-g09d2