From 04c562941c65c0f62f39179c0c2cf4f580c6960f Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Fri, 3 May 2024 11:17:28 -0400 Subject: sensor_ldc1612: Add support for chips with INTB line routed to mcu If the INTB line is available it can reduce the MCU load. Signed-off-by: Kevin O'Connor --- docs/Config_Reference.md | 3 +++ 1 file changed, 3 insertions(+) (limited to 'docs/Config_Reference.md') diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index 1338d46f..6b42fe48 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -2007,6 +2007,9 @@ Support for eddy current inductive probes. One may define this section sensor_type: ldc1612 # The sensor chip used to perform eddy current measurements. This # parameter must be provided and must be set to ldc1612. +#intb_pin: +# MCU gpio pin connected to the ldc1612 sensor's INTB pin (if +# available). The default is to not use the INTB pin. #z_offset: # The nominal distance (in mm) between the nozzle and bed that a # probing attempt should stop at. This parameter must be provided. -- cgit v1.2.3-70-g09d2