From a8b282d67a085714b3dab02fbc6afacd7351ae29 Mon Sep 17 00:00:00 2001 From: Dmitry Butyugin Date: Fri, 29 Jan 2021 20:47:10 +0100 Subject: resonance_tester: Disable input shaping for resonance testing Signed-off-by: Dmitry Butyugin --- docs/Config_Changes.md | 5 +++++ 1 file changed, 5 insertions(+) (limited to 'docs/Config_Changes.md') diff --git a/docs/Config_Changes.md b/docs/Config_Changes.md index 2e2375f2..19b745d2 100644 --- a/docs/Config_Changes.md +++ b/docs/Config_Changes.md @@ -6,6 +6,11 @@ All dates in this document are approximate. # Changes +20210201: The `TEST_RESONANCES` command will now disable input shaping +if it was previously enabled (and re-enable it after the test). In order +to override this behavior and keep the input shaping enabled, one can +pass an additional parameter `INPUT_SHAPING=1` to the command. + 20210201: The `ACCELEROMETER_MEASURE` command will now append the name of the accelerometer chip to the output file name if the chip was given a name in the corresponding adxl345 section of the printer.cfg. -- cgit v1.2.3-70-g09d2