From 077a56c2ca0315957efa8969221b850ed34c2cf7 Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Mon, 29 Jan 2018 10:16:42 -0500 Subject: mcu: Default the restart method to 'command' on non-serial ports If the mcu supports command restarts and it does not appear to use a real serial port, then default the restart method to 'command'. This is a better default on boards with native USB support. Signed-off-by: Kevin O'Connor --- config/example.cfg | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) (limited to 'config/example.cfg') diff --git a/config/example.cfg b/config/example.cfg index a7d6fd3d..bc71d46c 100644 --- a/config/example.cfg +++ b/config/example.cfg @@ -264,7 +264,7 @@ serial: /dev/ttyACM0 pin_map: arduino # This option may be used to enable Arduino pin name aliases. The # default is to not enable the aliases. -#restart_method: arduino +#restart_method: # This controls the mechanism the host will use to reset the # micro-controller. The choices are 'arduino', 'rpi_usb', and # 'command'. The 'arduino' method (toggle DTR) is common on Arduino @@ -273,7 +273,8 @@ pin_map: arduino # disables power to all USB ports to accomplish a micro-controller # reset. The 'command' method involves sending a Klipper command to # the micro-controller so that it can reset itself. The default is -# 'arduino'. +# 'arduino' if the micro-controller communicates over a serial port, +# 'command' otherwise. # The printer section controls high level printer settings. [printer] -- cgit v1.2.3-70-g09d2