From fc85675145c858e2817d6c10f73029fd4aab4b9e Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Wed, 9 Sep 2020 14:16:42 -0400 Subject: gcode_button: Add support for analog buttons Signed-off-by: Kevin O'Connor --- config/example-extras.cfg | 8 ++++++++ 1 file changed, 8 insertions(+) (limited to 'config/example-extras.cfg') diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 02647458..ce981c7e 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -1330,6 +1330,14 @@ #pin: # The pin on which the button is connected. This parameter must be # provided. +#analog_range: +# Two comma separated resistances (in Ohms) specifying the minimum +# and maximum resistance range for the button. If analog_range is +# provided then the pin must be an analog capable pin. The default +# is to use digital gpio for the button. +#analog_pullup_resistor: +# The pullup resistance (in Ohms) when analog_range is specified. +# The default is 4700 ohms. #press_gcode: # A list of G-Code commands to execute when the button is pressed. # G-Code templates are supported. This parameter must be provided. -- cgit v1.2.3-70-g09d2