From eebd7e6579690f279cf3693b9869c9571994f249 Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Fri, 1 May 2020 12:37:26 -0400 Subject: docs: Update bltouch probe_with_touch_mode documentation Signed-off-by: Kevin O'Connor --- config/example-extras.cfg | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) (limited to 'config/example-extras.cfg') diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 3b21caff..e254a50e 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -630,8 +630,8 @@ # using this mode requires careful tuning of probing speed # parameters. The default is True. #probe_with_touch_mode: False -# You can elect to probe in touch mode if you want. Note that this -# is not supported by all probe types. +# If this is set to True then Klipper will probe with the device in +# "touch_mode". The default is False (probing in "pin_down" mode). #pin_up_reports_not_triggered: True # Set if the BLTouch consistently reports the probe in a "not # triggered" state after a successful "pin_up" command. This should -- cgit v1.2.3-70-g09d2