aboutsummaryrefslogtreecommitdiffstats
path: root/test/klippy/gcode_arcs.test
Commit message (Collapse)AuthorAgeFilesLines
* gcode_arcs: Add back in support for E moves in absolute extrude modeKevin O'Connor2020-06-041-1/+0
| | | | | | | | | | | | This reverts commit 43fa41c1af648ea626040e17f0eebda39dcdb2cb. The above commit disabled absolute extrude moves because it was unclear if the code would work properly when an M221 extrude factor or G92 offset was in use. However, since the calculation is done relative to the raw E position and is sent as a raw E position to gcode.cmd_G1() these modes should not matter. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
* gcode_arcs: Disable E moves in absolute extrude modeKevin O'Connor2020-04-231-0/+1
| | | | | | | | Commit 402110f6 didn't actually fix absolute extrude mode. For now, report an error if an extrude move is requested in absolute extrude mode. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
* test: Add initial test case for gcode_arcs supportKevin O'Connor2019-09-131-0/+11
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
generated by cgit v1.2.3-70-g09d2 (git 2.50.1) at 2025-09-02 11:02:10 +0000