aboutsummaryrefslogtreecommitdiffstats
path: root/klippy/heater.py
Commit message (Collapse)AuthorAgeFilesLines
...
* heater: Do not require target temperature be above min_extrude_tempKevin O'Connor2016-11-081-5/+2
| | | | | | | | | | Only disable the extruder if the last measured temperature is below the minimum extrude temperature setting. Verifying the target temperature is not necessary, and it can incorrectly prevent some valid moves. It's not uncommon for scripts to retract filament immiedietly after setting the extruder temperature to zero. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
* heater: Make it possible to disable min_extrude_temp for testingKevin O'Connor2016-10-111-1/+1
| | | | | | | | Allow a config file to specify 'min_extrude_temp: 0' to disable the minimum extrude temperature test. This makes it easier to perform testing on the avr simulator. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
* extruder: Support a minimum extrude temperatureKevin O'Connor2016-09-301-0/+8
| | | | | | | | Allow the config file to specify the minimum temperature for the extruder and check for that temperature prior to moving the extruder motor. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
* heater: Add "ATC Semitec 104GT-2" thermistor definitionKevin O'Connor2016-09-151-1/+3
| | | | Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
* heater: Remove redundant float conversionKevin O'Connor2016-09-151-1/+1
| | | | Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
* mcu: Convert PWM and ADC objects to take mcu_time instead of clockKevin O'Connor2016-08-241-58/+46
| | | | Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
* Initial commit of source code.Kevin O'Connor2016-05-251-0/+288
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
generated by cgit v1.2.3-70-g09d2 (git 2.50.1) at 2025-09-03 05:54:45 +0000