diff options
Diffstat (limited to 'docs')
| -rw-r--r-- | docs/Config_Reference.md | 34 | ||||
| -rw-r--r-- | docs/G-Codes.md | 24 |
2 files changed, 58 insertions, 0 deletions
diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index ded1f062..1c86acf5 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -3750,3 +3750,37 @@ I2C bus. # On some micro-controllers changing this value has no effect. The # default is 100000. ``` + +# Other Custom Modules + +## [palette2] + +Palette 2 multimaterial support - provides a tighter integration +supporting Palette 2 devices in connected mode. + +This modules also requires `[virtual_sdcard]` and `[pause_resume]` +for full functionality. + +If you use this module, do not use the Palette 2 plugin for +Octoprint as they will conflict, and 1 will fail to initialize +properly likely aborting your print. + +If you use Octoprint and stream gcode over the serial port instead of +printing from virtual_sd, then remo **M1** and **M0** from *Pausing commands* +in *Settings > Serial Connection > Firmware & protocol* will prevent +the need to start print on the Palette 2 and unpausing in Octoprint +for your print to begin. + +``` +[palette2] +serial: +# The serial port to connect to the Palette 2. +#baud: 250000 +# The baud rate to use. The default is 250000. +#feedrate_splice: 0.8 +# The feedrate to use when splicing, default is 0.8 +#feedrate_normal: 1.0 +# The feedrate to use after splicing, default is 1.0 +#auto_load_speed: 2 +# Extrude feedrate when autoloading, default is 2 (mm/s) +``` diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 00ecdad8..70af24ef 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -760,3 +760,27 @@ is enabled (also see the defaults to the current time in "YYYYMMDD_HHMMSS" format. Note that the suggested input shaper parameters can be persisted in the config by issuing `SAVE_CONFIG` command. + +## Palette 2 Commands + +The following command is available when the +[palette2 config section](Config_Reference.md#palette2) +is enabled: +- `PALETTE_CONNECT`: This command initializes the connection with + the Palette 2. +- `PALETTE_DISCONNECT`: This command disconnects from the Palette 2. +- `PALETTE_CLEAR`: This command instructs the Palette 2 to clear all of the + input and output paths of filament. +- `PALETTE_CUT`: This command instructs the Palette 2 to cut the filament + currently loaded in the splice core. +- `PALETTE_SMART_LOAD`: This command start the smart load sequence on the + Palette 2. Filament is loaded automatically by extruding it the distance + calibrated on the device for the printer, and instructs the Palette 2 + once the loading has been completed. This command is the same as pressing + **Smart Load** directly on the Palette 2 screen after the filament load + is complete. + +Palette prints work by embedding special OCodes (Omega Codes) +in the GCode file: +- `O1`...`O32`: These codes are read from the GCode stream and processed + by this module and passed to the Palette 2 device. |