diff options
Diffstat (limited to 'docs')
| -rw-r--r-- | docs/Command_Templates.md | 2 | ||||
| -rw-r--r-- | docs/Config_Reference.md | 21 |
2 files changed, 23 insertions, 0 deletions
diff --git a/docs/Command_Templates.md b/docs/Command_Templates.md index 37e59fb8..e577decb 100644 --- a/docs/Command_Templates.md +++ b/docs/Command_Templates.md @@ -256,6 +256,8 @@ The following are common printer attributes: from the sensor. - `printer["lm75 <sensor_name>"].temperature`: The last read temperature from the sensor. +- `printer["rpi_temperature <sensor_name>"].temperature`: The last read + temperature from the sensor. - `printer["temperature_sensor <config_name>"].temperature`: The last read temperature from the sensor. - `printer["temperature_sensor <config_name>"].measured_min_temp`, diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index 5b0a8b54..cb9e3a6e 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -2058,6 +2058,27 @@ but this mode is not used here. # 0.5. ``` +## RPi temperature sensor + +CPU temperature from Raspberry Pi. + +``` +#[temperature_sensor my_sensor] +# See the "temperature_sensor" section for a description of its +# parameters. The parameters below describe the Raspberry Pi sensor +# parameters. +#sensor_type: +# Must be "rpi_temperature". +min_temp: -40 +max_temp: 85 +# The maximum safe range of temperatures (in Celsius) that the +# RPi must remain within. This controls a safety feature +# implemented in the micro-controller code - should the measured +# temperature ever fall outside this range then the micro-controller +# will go into a shutdown state. Set this range just wide +# enough so that reasonable temperatures do not result in an error. +``` + ## [heater_generic] Generic heaters (one may define any number of sections with a |