diff options
Diffstat (limited to 'docs')
| -rw-r--r-- | docs/G-Codes.md | 39 |
1 files changed, 27 insertions, 12 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 70e3abe2..4d40956f 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -212,18 +212,33 @@ The following standard commands are supported: babystepping), and subtract it from the stepper_z endstop_position. This acts to take a frequently used babystepping value, and "make it permanent". Requires a `SAVE_CONFIG` to take effect. -- `TUNING_TOWER COMMAND=<command> PARAMETER=<name> START=<value> - FACTOR=<value> [BAND=<value>] [SKIP=<value>]`: A tool for tuning - a parameter on each Z height during a print. The tool will run - the given COMMAND with the given PARAMETER assigned to the value - using the formula `value = start + factor * z_height`. If BAND is - provided then the adjustment will only be made every BAND - millimeters of z height - in that case the formula used is - `value = start + factor * ((floor(z_height / band) + .5) * band)`. - If `SKIP=<value>` is specified, the tuning process doesn't begin - until Z height `<value>` is reached, and below that the value will - be set to `START`; in this case, the `z_height` used in the - formulas above is actually `max(z - skip, 0)`. +- `TUNING_TOWER COMMAND=<command> PARAMETER=<name> START=<value> [SKIP=<value>] + [FACTOR=<value> [BAND=<value>]] | [STEP_DELTA=<value> STEP_HEIGHT=<value>]`: + A tool for tuning a parameter on each Z height during a print. + The tool will run the given `COMMAND` with the given `PARAMETER` + assigned to a value that varies with `Z` according to a formula. Use `FACTOR` + if you will use a ruler or calipers to measure the Z height of the optimum + value, or `STEP_DELTA` and `STEP_HEIGHT` if the tuning tower model has bands + of discrete values as is common with temperature towers. If `SKIP=<value>` + is specified, the tuning process doesn't begin until Z height `<value>` is + reached, and below that the value will be set to `START`; in this case, the + `z_height` used in the formulas below is actually `max(z - skip, 0)`. + There are three possible combinations of options: + - `FACTOR`: The value changes at a rate of `factor` per millimeter. + The formula used is + `value = start + factor * z_height`. + You can plug the optimum Z height directly into the formula to + determine the optimum parameter value. + - `FACTOR` and `BAND`: The value changes at an average rate of `factor` per + millimeter, but in discrete bands where the adjustment will only be made + every `BAND` millimeters of Z height. + The formula used is + `value = start + factor * ((floor(z_height / band) + .5) * band)`. + - `STEP_DELTA` and `STEP_HEIGHT`: The value changes by `STEP_DELTA` every + `STEP_HEIGHT` millimeters. The formula used is + `value = start + step_delta * floor(z_height / step_height)`. + You can simply count bands or read tuning tower labels to determine the + optimum value. - `SET_DISPLAY_GROUP [DISPLAY=<display>] GROUP=<group>`: Set the active display group of an lcd display. This allows to define multiple display data groups in the config, |