diff options
Diffstat (limited to 'docs')
| -rw-r--r-- | docs/Pressure_Advance.md | 14 |
1 files changed, 7 insertions, 7 deletions
diff --git a/docs/Pressure_Advance.md b/docs/Pressure_Advance.md index 84372e0c..e0d4ef28 100644 --- a/docs/Pressure_Advance.md +++ b/docs/Pressure_Advance.md @@ -16,13 +16,13 @@ Start by changing the extruder section of the config file so that pressure_advance is set to 0.0. (Make sure to issue a RESTART command after each update to the config file so that the new configuration takes effect.) Then print at least 10 layers of a large hollow square -at high speed (eg, 100mm/s). See **docs/prints/square.stl** file for -an STL file that one may use. While the object is printing, make a -note of which direction the head is moving during external -perimeters. What many people see here is blobbing occurring at the -corners - extra filament at the corner in the direction the head -travels followed by a possible lack of filament on the side -immediately after that corner: +at high speed (eg, 100mm/s). See +[docs/prints/square.stl](prints/square.stl) file for an STL file that +one may use. While the object is printing, make a note of which +direction the head is moving during external perimeters. What many +people see here is blobbing occurring at the corners - extra filament +at the corner in the direction the head travels followed by a possible +lack of filament on the side immediately after that corner:  |