diff options
Diffstat (limited to 'docs/Manual_Level.md')
| -rw-r--r-- | docs/Manual_Level.md | 6 |
1 files changed, 6 insertions, 0 deletions
diff --git a/docs/Manual_Level.md b/docs/Manual_Level.md index 38327c97..3ae75447 100644 --- a/docs/Manual_Level.md +++ b/docs/Manual_Level.md @@ -185,3 +185,9 @@ This means that: Repeat the process several times until you get a good level bed - normally when all adjustments are below 6 minutes. + +If using a probe that is mounted on the side of the hotend (that is, +it has an X or Y offset) then note that adjusting the bed tilt will +invalidate any previous probe calibration that was performed with a +tilted bed. Be sure to run [probe calibration](Probe_Calibrate.md) +after the bed screws have been adjusted. |