diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 8 |
1 files changed, 8 insertions, 0 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index b921e3ce..d3da572b 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -55,6 +55,14 @@ config section is enabled: - Display Message: `M117 <message>` - Set build percentage: `M73 P<percent>` +## Other available G-Code commands + +The following standard G-Code commands are currently available, but +using them is not recommended: +- Offset axes: `M206 [X<offset>] [Y<offset>] [Z<offset>]` (Use + SET_GCODE_OFFSET instead.) +- Get Endstop Status: `M119` (Use QUERY_ENDSTOPS instead.) + # Extended G-Code Commands Klipper uses "extended" G-Code commands for general configuration and |