diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 24 |
1 files changed, 24 insertions, 0 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 00ecdad8..70af24ef 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -760,3 +760,27 @@ is enabled (also see the defaults to the current time in "YYYYMMDD_HHMMSS" format. Note that the suggested input shaper parameters can be persisted in the config by issuing `SAVE_CONFIG` command. + +## Palette 2 Commands + +The following command is available when the +[palette2 config section](Config_Reference.md#palette2) +is enabled: +- `PALETTE_CONNECT`: This command initializes the connection with + the Palette 2. +- `PALETTE_DISCONNECT`: This command disconnects from the Palette 2. +- `PALETTE_CLEAR`: This command instructs the Palette 2 to clear all of the + input and output paths of filament. +- `PALETTE_CUT`: This command instructs the Palette 2 to cut the filament + currently loaded in the splice core. +- `PALETTE_SMART_LOAD`: This command start the smart load sequence on the + Palette 2. Filament is loaded automatically by extruding it the distance + calibrated on the device for the printer, and instructs the Palette 2 + once the loading has been completed. This command is the same as pressing + **Smart Load** directly on the Palette 2 screen after the filament load + is complete. + +Palette prints work by embedding special OCodes (Omega Codes) +in the GCode file: +- `O1`...`O32`: These codes are read from the GCode stream and processed + by this module and passed to the Palette 2 device. |