diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 27 |
1 files changed, 27 insertions, 0 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 01e16570..12070f1d 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -841,3 +841,30 @@ Palette prints work by embedding special OCodes (Omega Codes) in the GCode file: - `O1`...`O32`: These codes are read from the GCode stream and processed by this module and passed to the Palette 2 device. + +### Filament Width Sensor Commands + +The following command is available when the +[tsl1401cl filament width sensor config section](Config_Reference.md#tsl1401cl_filament_width_sensor) +or [hall filament width sensor config section](Config_Reference.md#hall_filament_width_sensor) +is enabled (also see [TSLl401CL Filament Width Sensor](TSL1401CL_Filament_Width_Sensor.md) +and [Hall Filament Width Sensor](Hall_Filament_Width_Sensor.md)): + +- `QUERY_FILAMENT_WIDTH` - Return the current measured filament width +- `RESET_FILAMENT_WIDTH_SENSOR` - Clear all sensor readings. Helpful after + filament change +- `DISABLE_FILAMENT_WIDTH_SENSOR` - Turn off the filament width sensor and + stop using it for flow control +- `ENABLE_FILAMENT_WIDTH_SENSOR` - Turn on the filament width sensor and + start using it for flow control + +### Hall Filament Width Sensor Commands + +The following command is available when the +[hall filament width sensor config section](Config_Reference.md#hall_filament_width_sensor) +is enabled: + +- `QUERY_RAW_FILAMENT_WIDTH` - Return the current ADC channel readings and + RAW sensor value for calibration points +- `ENABLE_FILAMENT_WIDTH_LOG` - Turn on diameter logging +- `DISABLE_FILAMENT_WIDTH_LOG` - Turn off diameter logging |