diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 8 |
1 files changed, 8 insertions, 0 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index cf5f2784..247a960a 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -160,6 +160,14 @@ The following standard commands are supported: for calibrating a Z position_endstop config setting. See the MANUAL_PROBE command for details on the parameters and the additional commands available while the tool is active. +- `TUNING_TOWER COMMAND=<command> PARAMETER=<name> START=<value> + FACTOR=<value> [BAND=<value>]`: A tool for tuning a parameter on + each Z height during a print. The tool will run the given COMMAND + with the given PARAMETER assigned to the value using the formula + `value = start + factor * z_height`. If BAND is provided then the + adjustment will only be made every BAND millimeters of z height - in + that case the formula used is `value = start + factor * + ((floor(z_height / band) + .5) * band)`. - `SET_IDLE_TIMEOUT [TIMEOUT=<timeout>]`: Allows the user to set the idle timeout (in seconds). - `RESTART`: This will cause the host software to reload its config |