diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 5 |
1 files changed, 3 insertions, 2 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 429dff74..aa795205 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -84,9 +84,10 @@ The following standard commands are supported: [ACCEL_TO_DECEL=<value>] [JUNCTION_DEVIATION=<value>]`: Modify the printer's velocity limits. Note that one may only set values less than or equal to the limits specified in the config file. -- `SET_PRESSURE_ADVANCE [ADVANCE=<pressure_advance>] +- `SET_PRESSURE_ADVANCE [EXTRUDER=<config_name>] [ADVANCE=<pressure_advance>] [ADVANCE_LOOKAHEAD_TIME=<pressure_advance_lookahead_time>]`: - Set pressure advance parameters. + Set pressure advance parameters. If EXTRUDER is not specified, it + defaults to the active extruder. - `RESTART`: This will cause the host software to reload its config and perform an internal reset. This command will not clear error state from the micro-controller (see FIRMWARE_RESTART) nor will it |