diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 18 |
1 files changed, 11 insertions, 7 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index dbc176ac..70e3abe2 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -213,13 +213,17 @@ The following standard commands are supported: This acts to take a frequently used babystepping value, and "make it permanent". Requires a `SAVE_CONFIG` to take effect. - `TUNING_TOWER COMMAND=<command> PARAMETER=<name> START=<value> - FACTOR=<value> [BAND=<value>]`: A tool for tuning a parameter on - each Z height during a print. The tool will run the given COMMAND - with the given PARAMETER assigned to the value using the formula - `value = start + factor * z_height`. If BAND is provided then the - adjustment will only be made every BAND millimeters of z height - in - that case the formula used is `value = start + factor * - ((floor(z_height / band) + .5) * band)`. + FACTOR=<value> [BAND=<value>] [SKIP=<value>]`: A tool for tuning + a parameter on each Z height during a print. The tool will run + the given COMMAND with the given PARAMETER assigned to the value + using the formula `value = start + factor * z_height`. If BAND is + provided then the adjustment will only be made every BAND + millimeters of z height - in that case the formula used is + `value = start + factor * ((floor(z_height / band) + .5) * band)`. + If `SKIP=<value>` is specified, the tuning process doesn't begin + until Z height `<value>` is reached, and below that the value will + be set to `START`; in this case, the `z_height` used in the + formulas above is actually `max(z - skip, 0)`. - `SET_DISPLAY_GROUP [DISPLAY=<display>] GROUP=<group>`: Set the active display group of an lcd display. This allows to define multiple display data groups in the config, |