diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 3 |
1 files changed, 2 insertions, 1 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 7a7da6cf..1f8e77c8 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -16,7 +16,8 @@ Klipper supports the following standard G-Code commands: - Set extrude factor override percentage: `M221 S<percent>` - Set acceleration: `M204 S<value>` OR `M204 P<value> T<value>` - Note: If S is not specified and both P and T are specified, then - the acceleration is set to the minimum of P and T. + the acceleration is set to the minimum of P and T. If only one of + P or T is specified, the command has no effect. - Get extruder temperature: `M105` - Set extruder temperature: `M104 [T<index>] [S<temperature>]` - Set extruder temperature and wait: `M109 [T<index>] S<temperature>` |