diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 10 |
1 files changed, 6 insertions, 4 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 92cb7660..3e32ba3f 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -184,10 +184,12 @@ SAVE_CONFIG gcode must be run to make the changes to persistent memory permanent. #### BED_MESH_OFFSET -`BED_MESH_OFFSET [X=<value>] [Y=<value>]`: Applies X and/or Y offsets -to the mesh lookup. This is useful for printers with independent -extruders, as an offset is necessary to produce correct Z adjustment -after a tool change. +`BED_MESH_OFFSET [X=<value>] [Y=<value>] [ZFADE=<value]`: Applies X, Y, +and/or ZFADE offsets to the mesh lookup. This is useful for printers with +independent extruders, as an offset is necessary to produce correct Z +adjustment after a tool change. Note that a ZFADE offset does not apply +additional z-adjustment directly, it is used to correct the `fade` +calculation when a `gcode offset` has been applied to the Z axis. ### [bed_screws] |