diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 6 |
1 files changed, 3 insertions, 3 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index d3da572b..25e30445 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -97,9 +97,9 @@ The following standard commands are supported: /tmp/heattest.txt will be created with a log of all temperature samples taken during the test. - `SET_VELOCITY_LIMIT [VELOCITY=<value>] [ACCEL=<value>] - [ACCEL_TO_DECEL=<value>] [JUNCTION_DEVIATION=<value>]`: Modify the - printer's velocity limits. Note that one may only set values less - than or equal to the limits specified in the config file. + [ACCEL_TO_DECEL=<value>] [SQUARE_CORNER_VELOCITY=<value>]`: Modify + the printer's velocity limits. Note that one may only set values + less than or equal to the limits specified in the config file. - `SET_PRESSURE_ADVANCE [EXTRUDER=<config_name>] [ADVANCE=<pressure_advance>] [ADVANCE_LOOKAHEAD_TIME=<pressure_advance_lookahead_time>]`: Set pressure advance parameters. If EXTRUDER is not specified, it |