diff options
Diffstat (limited to 'docs/Delta_Calibrate.md')
| -rw-r--r-- | docs/Delta_Calibrate.md | 15 |
1 files changed, 8 insertions, 7 deletions
diff --git a/docs/Delta_Calibrate.md b/docs/Delta_Calibrate.md index ecc287c9..d8079456 100644 --- a/docs/Delta_Calibrate.md +++ b/docs/Delta_Calibrate.md @@ -42,13 +42,14 @@ There are two ways to perform the probing - manual probing (`DELTA_CALIBRATE`). Automatic probing utilizes a hardware device capable of triggering when the toolhead is at a set distance from the bed. The manual probing method will move the head near the bed and -then wait for the user to follow the -["paper test"](Bed_Level.md#the-paper-test) steps. It is recommended -to use manual probing for delta calibration. A number of common -printer kits come with probes that are not sufficiently accurate -(specifically, small differences in arm length can cause effector tilt -which can skew an automatic probe). Manual probing only takes a few -minutes and it eliminates error introduced by the probe. +then wait for the user to follow the steps described at +["the paper test"](Bed_Level.md#the-paper-test) to determine the +actual distance between the nozzle and bed at the given location. It +is recommended to use manual probing for delta calibration. A number +of common printer kits come with probes that are not sufficiently +accurate (specifically, small differences in arm length can cause +effector tilt which can skew an automatic probe). Manual probing only +takes a few minutes and it eliminates error introduced by the probe. To perform the basic probe, make sure the config has a [delta_calibrate] section defined and run: |