diff options
Diffstat (limited to 'docs/Axis_Twist_Compensation.md')
| -rw-r--r-- | docs/Axis_Twist_Compensation.md | 59 |
1 files changed, 45 insertions, 14 deletions
diff --git a/docs/Axis_Twist_Compensation.md b/docs/Axis_Twist_Compensation.md index ee582aca..b0c80b18 100644 --- a/docs/Axis_Twist_Compensation.md +++ b/docs/Axis_Twist_Compensation.md @@ -24,20 +24,51 @@ try to probe the bed without attaching the probe if you use it. > **Tip:** Make sure the [probe X and Y offsets](Config_Reference.md#probe) are > correctly set as they greatly influence calibration. -1. After setting up the [axis_twist_compensation] module, -perform `AXIS_TWIST_COMPENSATION_CALIBRATE` -* The calibration wizard will prompt you to measure the probe Z offset at a few -points along the bed -* The calibration defaults to 3 points but you can use the option -`SAMPLE_COUNT=` to use a different number. -* For Y-axis calibration, use `AXIS_TWIST_COMPENSATION_CALIBRATE AXIS=Y` instead. -2. [Adjust your Z offset](Probe_Calibrate.md#calibrating-probe-z-offset) -3. Perform automatic/probe-based bed tramming operations, such as -[Screws Tilt Adjust](G-Codes.md#screws_tilt_adjust), -[Z Tilt Adjust](G-Codes.md#z_tilt_adjust) etc -4. Home all axis, then perform a [Bed Mesh](Bed_Mesh.md) if required -5. Perform a test print, followed by any -[fine-tuning](Axis_Twist_Compensation.md#fine-tuning) as desired +### Basic Usage: X-Axis Calibration +1. After setting up the ```[axis_twist_compensation]``` module, run: +``` +AXIS_TWIST_COMPENSATION_CALIBRATE +``` +This command will calibrate the X-axis by default. + - The calibration wizard will prompt you to measure the probe Z offset at + several points along the bed. + - By default, the calibration uses 3 points, but you can specify a different + number with the option: +`` +SAMPLE_COUNT=<value> +`` + +2. **Adjust Your Z Offset:** +After completing the calibration, be sure to [adjust your Z offset] +(Probe_Calibrate.md#calibrating-probe-z-offset). + +3. **Perform Bed Leveling Operations:** +Use probe-based operations as needed, such as: + - [Screws Tilt Adjust](G-Codes.md#screws_tilt_adjust) + - [Z Tilt Adjust](G-Codes.md#z_tilt_adjust) + +4. **Finalize the Setup:** + - Home all axes, and perform a [Bed Mesh](Bed_Mesh.md) if necessary. + - Run a test print, followed by any + [fine-tuning](Axis_Twist_Compensation.md#fine-tuning) + if needed. + +### For Y-Axis Calibration +The calibration process for the Y-axis is similar to the X-axis. To calibrate +the Y-axis, use: +``` +AXIS_TWIST_COMPENSATION_CALIBRATE AXIS=Y +``` +This will guide you through the same measuring process as for the X-axis. + +### Automatic Calibration for Both Axes +To perform automatic calibration for both the X and Y axes without manual +intervention, use: +``` +AXIS_TWIST_COMPENSATION_CALIBRATE AUTO=True +``` +In this mode, the calibration process will run for both axes automatically. + > **Tip:** Bed temperature and nozzle temperature and size do not seem to have > an influence to the calibration process. |