diff options
Diffstat (limited to 'config')
| -rw-r--r-- | config/example-extras.cfg | 35 |
1 files changed, 35 insertions, 0 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index c26b03c8..bc8b07d7 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -1845,6 +1845,41 @@ # The distance from sensor to the melting chamber as mm #measurement_delay: 100 +# Hall filament width sensor (see docs/HallFilamentWidthSensor.md) +#[hall_filament_width_sensor] +#adc1: analog11 +#adc2: analog12 +# Analog input pins connected to the sensor. These parameters must +# be provided. +#cal_dia1: 1.50 +#cal_dia2: 2.00 +# The calibration values (in mm) for the sensors. The default is +# 1.50 for cal_dia1 and 2.00 for cal_dia2. +#raw_dia1: 9500 +#raw_dia2: 10500 +# The raw calibration values for the sensors. The default is 9500 +# for raw_dia1 and 10500 for raw_dia2. +#default_nominal_filament_diameter: 1.75 +# The nominal filament diameter. This parameter must be provided. +#max_difference: 0.200 +# Maximum allowed filament diameter difference in millimeters (mm). +# If difference between nominal filament diameter and sensor output +# is more than +- max_difference, extrusion multiplier is set back +# to %100. The default is 0.200. +#measurement_delay: 70 +# The distance from sensor to the melting chamber/hot-end in +# millimeters (mm). The filament between the sensor and the hot-end +# will be treated as the default_nominal_filament_diameter. Host +# module works with FIFO logic. It keeps each sensor value and +# position in an array and POP them back in correct position. This +# parameter must be provided. +#enable: False +# Sensor enabled or disabled after power on. The default is to +# disable. +#measurement_interval: 10 +# The approximate distance (in mm) between sensor readings. The +# default is 10mm. + ###################################################################### # Board specific hardware support |