diff options
Diffstat (limited to 'config')
| -rw-r--r-- | config/example-extras.cfg | 22 |
1 files changed, 15 insertions, 7 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 34f1c4e1..a4e52dde 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -1051,13 +1051,13 @@ # sections with an "adc_temperature" prefix). This allows one to # define a custom temperature sensor that measures a voltage on an # Analog to Digital Converter (ADC) pin and uses linear interpolation -# between a set of configured temperature/voltage measurements to -# determine the temperature. The resulting sensor can be used as a -# sensor_type in a heater section. (For example, if one defines a -# "[adc_temperature my_sensor]" section then one may use a -# "sensor_type: my_sensor" when defining a heater.) Be sure to place -# the sensor section in the config file above its first use in a -# heater section. +# between a set of configured temperature/voltage (or +# temperature/resistance) measurements to determine the +# temperature. The resulting sensor can be used as a sensor_type in a +# heater section. (For example, if one defines a "[adc_temperature +# my_sensor]" section then one may use a "sensor_type: my_sensor" when +# defining a heater.) Be sure to place the sensor section in the +# config file above its first use in a heater section. #[adc_temperature my_sensor] #temperature1: #voltage1: @@ -1067,6 +1067,14 @@ # A set of temperatures (in Celsius) and voltages (in Volts) to use # as reference when converting a temperature. At least two # measurements must be provided. +#temperature1: +#resistance1: +#temperature2: +#resistance2: +#... +# Alternatively one may specify a set of temperatures (in Celsius) +# and resistance (in Ohms) to use as reference when converting a +# temperature. At least two measurements must be provided. # MAXxxxxx serial peripheral interface (SPI) temperature based |