diff options
Diffstat (limited to 'config')
| -rw-r--r-- | config/printer-creality-ender3-v2-2020.cfg (renamed from config/printer-creality-ender-3-v2-2020.cfg) | 14 |
1 files changed, 8 insertions, 6 deletions
diff --git a/config/printer-creality-ender-3-v2-2020.cfg b/config/printer-creality-ender3-v2-2020.cfg index c60bdb4f..4dee7b6f 100644 --- a/config/printer-creality-ender-3-v2-2020.cfg +++ b/config/printer-creality-ender3-v2-2020.cfg @@ -1,10 +1,12 @@ -# This file contains pin mappings for the stock 2020 Creality -# Ender 3 V2. To use this config, the firmware should be compiled -# for the STM32F103 with a 28KiB bootloader. To use the front USB -# port for communication, select serial port USART1. +# This file contains pin mappings for the stock 2020 Creality Ender 3 +# V2. To use this config, during "make menuconfig" select the +# STM32F103 with a "28KiB bootloader" and with "Use USB for +# communication" disabled. -# If you prefer a direct serial connection, USART3 is broken out -# on the 10 pin IDC cable used for the LCD module as follows: +# If you prefer a direct serial connection, in "make menuconfig" +# select "Enable extra low-level configuration options" and select the +# USART3 serial port, which is broken out on the 10 pin IDC cable used +# for the LCD module as follows: # 3: Tx, 4: Rx, 9: GND, 10: VCC # Flash this firmware by copying "out/klipper.bin" to a SD card and |