diff options
Diffstat (limited to 'config/printer-creality-ender3pro-2020.cfg')
| -rw-r--r-- | config/printer-creality-ender3pro-2020.cfg | 8 |
1 files changed, 4 insertions, 4 deletions
diff --git a/config/printer-creality-ender3pro-2020.cfg b/config/printer-creality-ender3pro-2020.cfg index b3a35528..04b5f004 100644 --- a/config/printer-creality-ender3pro-2020.cfg +++ b/config/printer-creality-ender3pro-2020.cfg @@ -1,12 +1,12 @@ # This file contains pin mappings for the stock 2020 Creality Ender 3 # Pro with the 32-bit Creality 4.2.2 board. To use this config, during # "make menuconfig" select the STM32F103 with a "28KiB bootloader" and -# with "Use USB for communication" disabled. +# serial (on USART1 PA10/PA9) communication. # If you prefer a direct serial connection, in "make menuconfig" -# select "Enable extra low-level configuration options" and select the -# USART3 serial port, which is broken out on the 10 pin IDC cable used -# for the LCD module as follows: +# select "Enable extra low-level configuration options" and select +# serial (on USART3 PB11/PB10), which is broken out on the 10 pin IDC +# cable used for the LCD module as follows: # 3: Tx, 4: Rx, 9: GND, 10: VCC # Flash this firmware by copying "out/klipper.bin" to a SD card and |