diff options
Diffstat (limited to 'config/generic-replicape.cfg')
| -rw-r--r-- | config/generic-replicape.cfg | 31 |
1 files changed, 0 insertions, 31 deletions
diff --git a/config/generic-replicape.cfg b/config/generic-replicape.cfg index fe361dea..f8e3063e 100644 --- a/config/generic-replicape.cfg +++ b/config/generic-replicape.cfg @@ -20,42 +20,11 @@ pin_map: beaglebone [mcu host] serial: /tmp/klipper_host_mcu -# The "replicape" config section adds "replicape:stepper_x_enable" -# virtual stepper enable pins (for steppers x, y, z, e, and h) and -# "replicape:power_x" PWM output pins (for hotbed, e, h, fan0, fan1, -# fan2, and fan3) that may then be used elsewhere in the config file. [replicape] revision: B3 -# The replicape hardware revision. Currently only revision "B3" is -# supported. This parameter must be provided. -#enable_pin: !P9_41 -# The replicape global enable pin. The default is !P9_41. host_mcu: host -# The name of the mcu config section that communicates with the -# Klipper "linux process" mcu instance. This parameter must be -# provided. -#standstill_power_down: False -# This parameter controls the CFG6_ENN line on all stepper -# motors. True sets the enable lines to "open". The default is -# False. stepper_x_microstep_mode: spread16 -# This parameter controls the CFG1 and CFG2 pins of the given -# stepper motor driver. Available options are: disable, 1, 2, -# spread2, 4, 16, spread4, spread16, stealth4, and stealth16. The -# default is disable. stepper_x_current: 0.5 -# The configured maximum current (in Amps) of the stepper motor -# driver. This parameter must be provided if the stepper is not in a -# disable mode. -#stepper_x_chopper_off_time_high: False -# This parameter controls the CFG0 pin of the stepper motor driver -# (True sets CFG0 high, False sets it low). The default is False. -#stepper_x_chopper_hysteresis_high: False -# This parameter controls the CFG4 pin of the stepper motor driver -# (True sets CFG4 high, False sets it low). The default is False. -#stepper_x_chopper_blank_time_high: True -# This parameter controls the CFG5 pin of the stepper motor driver -# (True sets CFG5 high, False sets it low). The default is True. stepper_y_microstep_mode: spread16 stepper_y_current: 0.5 stepper_z_microstep_mode: spread16 |