diff options
Diffstat (limited to 'config/example.cfg')
| -rw-r--r-- | config/example.cfg | 35 |
1 files changed, 17 insertions, 18 deletions
diff --git a/config/example.cfg b/config/example.cfg index 344c525d..a086977c 100644 --- a/config/example.cfg +++ b/config/example.cfg @@ -100,29 +100,28 @@ nozzle_diameter: 0.500 # Diameter of the nozzle orifice (in mm). This parameter must be # provided. filament_diameter: 3.500 -# Diameter of the raw filament (in mm) as it enters the +# The nominal diameter of the raw filament (in mm) as it enters the # extruder. This parameter must be provided. #max_extrude_cross_section: -# Maximum area of the cross section of an extrusion line (in -# mm^2). This setting prevents excessive amounts of extrusion during -# relatively small XY moves. If a move requests an extrusion rate -# that would exceed this value it will cause an error to be -# returned. The default is: 4.0 * nozzle_diameter^2 +# Maximum area (in mm^2) of an extrusion cross section (eg, +# extrusion width multiplied by layer height). This setting prevents +# excessive amounts of extrusion during relatively small XY moves. +# If a move requests an extrusion rate that would exceed this value +# it will cause an error to be returned. The default is: 4.0 * +# nozzle_diameter^2 #max_extrude_only_distance: 50.0 -# Maximum length (in mm of raw filament) that an extrude only move -# may be. If an extrude only move requests a distance greater than -# this value it will cause an error to be returned. The default is -# 50mm. +# Maximum length (in mm of raw filament) that a retraction or +# extrude-only move may have. If a retraction or extrude-only move +# requests a distance greater than this value it will cause an error +# to be returned. The default is 50mm. #max_extrude_only_velocity: -# Maximum velocity (in mm/s) of the extruder motor for extrude only -# moves. If this is not specified then it is calculated to match the -# limit an XY printing move with a max_extrude_cross_section -# extrusion would have. #max_extrude_only_accel: -# Maximum acceleration (in mm/s^2) of the extruder motor for extrude -# only moves. If this is not specified then it is calculated to -# match the limit an XY printing move with a -# max_extrude_cross_section extrusion would have. +# Maximum velocity (in mm/s) and acceleration (in mm/s^2) of the +# extruder motor for retractions and extrude-only moves. These +# settings do not place any limit on normal printing moves. If not +# specified then they are calculated to match the limit an XY +# printing move with a max_extrude_cross_section extrusion would +# have. #pressure_advance: 0.0 # The amount of raw filament to push into the extruder during # extruder acceleration. An equal amount of filament is retracted |