diff options
Diffstat (limited to 'config/example.cfg')
| -rw-r--r-- | config/example.cfg | 11 |
1 files changed, 5 insertions, 6 deletions
diff --git a/config/example.cfg b/config/example.cfg index 5614b5fc..090f3653 100644 --- a/config/example.cfg +++ b/config/example.cfg @@ -5,10 +5,9 @@ # FIRST. Incorrectly configured parameters may cause damage. # A note on pin names: pins may be configured with a hardware name -# (such as PA4) or with a board name (such as ar29). In order to use a -# board name, the pin_map variable in the mcu section must specify -# which board definition to use. (See the klippy/pins.py file for the -# available pin and board names.) +# (such as "PA4") or with an Arduino alias name (such as "ar29" or +# "analog3"). In order to use Arduino names, the pin_map variable in +# the mcu section must be present and have a value of "arduino". # Pin names may be preceded by an '!' to indicate that a reverse # polarity should be used (eg, trigger on low instead of high). Input # pins may be preceded by a '^' to indicate that a hardware pull-up @@ -173,10 +172,10 @@ kick_start_time: 0.100 [mcu] serial: /dev/ttyACM0 # The serial port to connect to the MCU -baud: 115200 +baud: 250000 # The baud rate to use pin_map: arduino -# This option may be used to add board specific pin name aliases +# This option may be used to enable Arduino pin name aliases custom: # This option may be used to specify a set of custom # micro-controller commands to be sent at the start of the |