diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 13 |
1 files changed, 0 insertions, 13 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index b48ca5c9..5b8f6909 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -677,19 +677,6 @@ # config section should define the heater and the extruder4 section # should specify "shared_heater: extruder3". The default is to not # reuse an existing heater. -#deactivate_gcode: -# A list of G-Code commands to execute on a G-Code tool change -# command (eg, "T1") that deactivates this extruder and activates -# some other extruder. See docs/Command_Templates.md for G-Code -# format. It only makes sense to define this section on -# multi-extruder printers. The default is to not run any special -# G-Code commands on deactivation. -#activate_gcode: -# A list of G-Code commands to execute on a G-Code tool change -# command (eg, "T0") that activates this extruder. See -# docs/Command_Templates.md for G-Code format. It only makes sense -# to define this section on multi-extruder printers. The default is -# to not run any special G-Code commands on activation. # Support for cartesian printers with dual carriages on a single # axis. The active carriage is set via the SET_DUAL_CARRIAGE extended |