diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 31 |
1 files changed, 31 insertions, 0 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 65d8115b..08fd6c4f 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -211,6 +211,37 @@ # is 1.0 +# Temperature-triggered cooling fans (one may define any number of +# sections with a "temperature_fan" prefix). A "temperature fan" is +# a fan that will be enabled whenever its associated sensor is above +# a set temperature. In the event of an MCU software error the +# temperature_fan will be set to its max_power. +#[temperature_fan my_temp_fan] +# See the "fan" section for fan configuration parameters. +#pin: ar4 +# See the "heater" section for details about the sensor_type and +# sensor_pin parameters. +#sensor_type: EPCOS 100K B57560G104F +#sensor_pin: analog13 +# The remaining variables are specific to temperature_fan. +#min_temp: 0 +#max_temp: 100 +# The maximum range of valid temperatures (in Celsius) that the +# sensor must remain within. This controls a safety feature +# implemented in the micro-controller code - should the measured +# temperature ever fall outside this range then the micro-controller +# will go into a shutdown state. Set this range just wide enough so +# that reasonable temperatures do not result in an error. These +# parameters must be provided. +#temp: 40.0 +# A temperature (in Celsius) that the sensor must exceed before the +# fan is enabled. The default is 40 Celsius. +#fan_speed: 1.0 +# The fan speed (expressed as a value from 0.0 to 1.0) that the fan +# will be set to when the sensor temperature exceeds the set value. +# The default is 1.0. + + # Additional micro-controllers (one may define any number of sections # with an "mcu" prefix). Additional micro-controllers introduce # additional pins that may be configured as heaters, steppers, fans, |