diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 17 |
1 files changed, 9 insertions, 8 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 53321aef..f7deeb61 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -890,27 +890,28 @@ #i2c_mcu: mcu # The name of the micro-controller that the MCP4451 chip is # connected to. The default is "mcu". -#i2c_address: +#i2c_address: 96 # The i2c address that the chip is using on the i2c bus. The default -# is zero. +# is 96. #channel_a: #channel_b: #channel_c: #channel_d: # The value to statically set the given MCP4728 channel to. This is # typically set to a number between 0.0 and 1.0 with 1.0 being the -# highest voltage and 0.0 being the lowest voltage. However, the -# range may be changed with the 'scale' parameter (see below). If a -# channel is not specified then it is left unconfigured. +# highest voltage (2.048V) and 0.0 being the lowest voltage. However, +# the range may be changed with the 'scale' parameter (see +# below). If a channel is not specified then it is left +# unconfigured. #scale: # This parameter can be used to alter how the 'channel_x' parameters # are interpreted. If provided, then the 'channel_x' parameters # should be between 0.0 and 'scale'. This may be useful when the # MCP4728 is used to set stepper voltage references. The 'scale' can # be set to the equivalent stepper amperage if the MCP4728 were at -# its highest voltage, and then the 'channel_x' parameters can be -# specified using the desired amperage value for the stepper. The -# default is to not scale the 'channel_x' parameters. +# its highest voltage (2.048V), and then the 'channel_x' parameters +# can be specified using the desired amperage value for the +# stepper. The default is to not scale the 'channel_x' parameters. # Statically configured MCP4018 digipot connected via two gpio "bit |