diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 34 |
1 files changed, 16 insertions, 18 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 5d319fe0..12fb3fab 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -610,8 +610,7 @@ # not run any special G-Code commands on deactivation. # BLTouch probe. One may define this section (instead of a probe -# section) to enable a BLTouch probe. (Note! This bltouch module may -# not work correctly with some BLTouch "clones"!) A virtual +# section) to enable a BLTouch probe. A virtual # "probe:z_virtual_endstop" pin is also created (see the "probe" # section above for the details). #[bltouch] @@ -624,28 +623,27 @@ #pin_move_time: 0.675 # The amount of time (in seconds) to wait for the BLTouch pin to # move up or down. The default is 0.675 seconds. +#stow_on_each_sample: True +# This determines if Klipper should command the pin to move up +# between each probe attempt when performing a multiple probe +# sequence. Setting this to False can allow for faster probing, but +# using this mode requires careful tuning of probing speed +# parameters. The default is True. #pin_up_reports_not_triggered: True # Set if the BLTouch consistently reports the probe in a "not # triggered" state after a successful "pin_up" command. This should -# be True for a genuine BLTouch; some BLTouch clones may require -# False. The default is True. +# be True for all genuine BLTouch devices. The default is True. #pin_up_touch_mode_reports_triggered: True # Set if the BLTouch consistently reports a "triggered" state after # the commands "pin_up" followed by "touch_mode". This should be -# True for a genuine BLTouch v2 and earlier; the BLTouch v3 and some -# BLTouch clones require False. The default is True. -#stow_on_each_sample: True -# If set to False, intermediate STOW/DEPLOY sequences on certain -# operations that use the probe multiple times will be omitted. -#set_ouput_mode: [Possible values: 5V, OD, or do not specify this -# parameter at all if you don't want a mode setting to be performed] -# A BLTouch Smart V3.0 or V3.1(+) supports selection of an output -# mode, 5V or OPEN DRAIN. If your controller board NEEDs 5V mode -# AND it is 5V tolerant on its input signal line, you can use this -# parameter. Note also that for a V3.1, it is possible to not specify -# this parameter at all and instead to manually use a "BLTOUCH_STORE -# MODE=" command to store the desired output mode permanently in the -# probes EEPROM (see the documentation for this command). +# True for all genuine BLTouch devices. The default is True. +#set_output_mode: +# Request a specific sensor pin output mode on the BLTouch V3.0 (and +# later). This setting should not be used on other types of probes. +# Set to "5V" to request a sensor pin output of 5 Volts (only use if +# the controller board needs 5V mode and is 5V tolerant on its input +# signal line). Set to "OD" to request the sensor pin output use +# open drain mode. The default is to not request an output mode. #x_offset: #y_offset: #z_offset: |