diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 22 |
1 files changed, 22 insertions, 0 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 82fdfd9d..0cc95b0f 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -65,6 +65,28 @@ # and true otherwise. +# Multiple Z stepper tilt adjustment. This feature enables independent +# adjustment of multiple z steppers (see stepper_z1 section below) to +# adjust for tilt. If this section is present then a Z_TILT_ADJUST +# extended G-Code command becomes available. +#[z_tilt] +#z_positions: +# A newline separated list of X,Y coordinates describing the +# location of each Z stepper. The first entry corresponds to +# stepper_z, the second to stepper_z1, the third to stepper_z2, +# etc. This parameter must be provided. +#points: +# A newline separated list of X,Y points that should be probed +# during a Z_TILT_ADJUST command. The default is to use the same +# positions described in z_positions. +#speed: 50 +# The speed (in mm/s) of non-probing moves during the calibration. +# The default is 50. +#horizontal_move_z: 5 +# The height (in mm) that the head should be commanded to move to +# just prior to starting a probe operation. The default is 5. + + # In a multi-extruder printer add an additional extruder section for # each additional extruder. The additional extruder sections should be # named "extruder1", "extruder2", "extruder3", and so on. See the |