diff options
Diffstat (limited to 'config/example-delta.cfg')
| -rw-r--r-- | config/example-delta.cfg | 25 |
1 files changed, 25 insertions, 0 deletions
diff --git a/config/example-delta.cfg b/config/example-delta.cfg index 3ae4c312..76d0cfc0 100644 --- a/config/example-delta.cfg +++ b/config/example-delta.cfg @@ -107,3 +107,28 @@ delta_radius: 174.75 # axis towers. This parameter may also be calculated as: # delta_radius = smooth_rod_offset - effector_offset - carriage_offset # This parameter must be provided. + +# The delta_calibrate section enables a DELTA_CALIBRATE extended +# g-code command that can calibrate the tower endstop positions and +# angles. +[delta_calibrate] +radius: 50 +# Radius (in mm) of the area that may be probed. This is typically +# the size of the printer bed. This parameter must be provided. +#speed: 50 +# The speed (in mm/s) of non-probing moves during the +# calibration. The default is 50. +#horizontal_move_z: 5 +# The height (in mm) that the head should be commanded to move to +# just prior to starting a probe operation. The default is 5. +#probe_z_offset: 0 +# The Z height (in mm) of the head when the probe triggers. The +# default is 0. +#manual_probe: +# If true, then DELTA_CALIBRATE will perform manual probing. If +# false, then a PROBE command will be run at each probe +# point. Manual probing is accomplished by manually jogging the Z +# position of the print head at each probe point and then issuing a +# NEXT extended g-code command to record the position at that +# point. The default is false if a [probe] config section is present +# and true otherwise. |