diff options
| -rw-r--r-- | docs/G-Codes.md | 22 |
1 files changed, 11 insertions, 11 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 1f88937a..0b8aa6e5 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -139,6 +139,17 @@ Writes raw "value" into register "register". Both "value" and and refer to sensor data sheet for the reference. This is only available for tle5012b chips. +### [axis_twist_compensation] + +The following commands are available when the +[axis_twist_compensation config +section](Config_Reference.md#axis_twist_compensation) is enabled. + +#### AXIS_TWIST_COMPENSATION_CALIBRATE +`AXIS_TWIST_COMPENSATION_CALIBRATE [SAMPLE_COUNT=<value>]`: Initiates the X +twist calibration wizard. `SAMPLE_COUNT` specifies the number of points along +the X axis to calibrate at and defaults to 3. + ### [bed_mesh] The following commands are available when the @@ -1353,17 +1364,6 @@ print. #### SDCARD_RESET_FILE `SDCARD_RESET_FILE`: Unload file and clear SD state. -### [axis_twist_compensation] - -The following commands are available when the -[axis_twist_compensation config -section](Config_Reference.md#axis_twist_compensation) is enabled. - -#### AXIS_TWIST_COMPENSATION_CALIBRATE -`AXIS_TWIST_COMPENSATION_CALIBRATE [SAMPLE_COUNT=<value>]`: Initiates the X -twist calibration wizard. `SAMPLE_COUNT` specifies the number of points along -the X axis to calibrate at and defaults to 3. - ### [z_thermal_adjust] The following commands are available when the |