diff options
| -rw-r--r-- | config/example.cfg | 16 |
1 files changed, 8 insertions, 8 deletions
diff --git a/config/example.cfg b/config/example.cfg index a0b8cf8b..0e0e5c4d 100644 --- a/config/example.cfg +++ b/config/example.cfg @@ -96,8 +96,7 @@ position_max: 200 # The extruder section is used to describe both the stepper # controlling the printer extruder and the heater parameters for the # nozzle. The stepper configuration has the same settings as the -# stepper_x section and the heater configuration has the same settings -# as the heater_bed section (described below). +# stepper_x section. [extruder] step_pin: ar26 dir_pin: ar28 @@ -193,6 +192,11 @@ pid_Kd: 114 #pid_integral_max: # The maximum "windup" the integral term may accumulate. The default # is to use the same value as max_power. +#max_delta: 2.0 +# On 'watermark' controlled heaters this is the number of degrees in +# Celsius above the target temperature before disabling the heater +# as well as the number of degrees below the target before +# re-enabling the heater. The default is 2 degrees Celsius. #pwm_cycle_time: 0.100 # Time in seconds for each software PWM cycle of the heater. It is # not recommended to set this unless there is an electrical @@ -213,17 +217,13 @@ max_temp: 210 # error. These parameters must be provided. # The heater_bed section describes a heated bed (if present - omit -# section if not present). +# section if not present). It uses the same heater settings described +# in the extruder section. [heater_bed] heater_pin: ar8 sensor_type: EPCOS 100K B57560G104F sensor_pin: analog14 control: watermark -#max_delta: 2.0 -# On 'watermark' controlled heaters this is the number of degrees in -# Celsius above the target temperature before disabling the heater -# as well as the number of degrees below the target before -# re-enabling the heater. The default is 2 degrees Celsius. min_temp: 0 max_temp: 110 |