diff options
| -rw-r--r-- | docs/FAQ.md | 24 |
1 files changed, 16 insertions, 8 deletions
diff --git a/docs/FAQ.md b/docs/FAQ.md index 31d4efab..642e62c4 100644 --- a/docs/FAQ.md +++ b/docs/FAQ.md @@ -462,7 +462,14 @@ step counter being off by a multiple of 64 microsteps.) ### How do I upgrade to the latest software? -The general way to upgrade is to ssh into the Raspberry Pi and run: +The first step to upgrading the software is to review the latest +[config changes](Config_Changes.md) document. On occasion, changes are +made to the software that require users to update their settings as +part of a software upgrade. It is a good idea to review this document +prior to upgrading. + +When ready to upgrade, the general method is to ssh into the Raspberry +Pi and run: ``` cd ~/klipper @@ -494,11 +501,12 @@ sudo service klipper restart If after using this shortcut the software warns about needing to reflash the micro-controller or some other unusual error occurs, then -follow the full upgrade steps outlined above. Note that the RESTART -and FIRMWARE_RESTART g-code commands do not load new software - the -above "sudo service klipper restart" and "make flash" commands are -needed for a software change to take effect. +follow the full upgrade steps outlined above. + +If any errors persist then double check the +[config changes](Config_Changes.md) document, as you may need to +modify the printer configuration. -When upgrading the software, be sure to check the -[config changes](Config_Changes.md) document for information on -software changes that may require updates to your printer.cfg file. +Note that the RESTART and FIRMWARE_RESTART g-code commands do not load +new software - the above "sudo service klipper restart" and "make +flash" commands are needed for a software change to take effect. |