diff options
| -rw-r--r-- | config/printer-creality-ender3-s1-2021.cfg | 4 | ||||
| -rw-r--r-- | config/printer-creality-ender3-s1pro-2022.cfg | 4 | ||||
| -rw-r--r-- | config/printer-creality-sermoonV1-2022.cfg | 3 |
3 files changed, 6 insertions, 5 deletions
diff --git a/config/printer-creality-ender3-s1-2021.cfg b/config/printer-creality-ender3-s1-2021.cfg index 766dd0f8..2be53726 100644 --- a/config/printer-creality-ender3-s1-2021.cfg +++ b/config/printer-creality-ender3-s1-2021.cfg @@ -2,8 +2,8 @@ # S1. To use this config, check the STM32 Chip on the V2.4S1 Board # then during "make menuconfig" select either the STM32F103 with a # "28KiB bootloader" or select the STM32F401 with a "64KiB bootloader" -# and serial (on USB PA10/PA9) communication for both depending on the -# STM32 Chip installed on your printers Motherboard. +# and serial (on USART1 PA10/PA9) communication for both depending on +# the STM32 chip installed on your printer's motherboard. # If you prefer a direct serial connection, in "make menuconfig" # select "Enable extra low-level configuration options" and select diff --git a/config/printer-creality-ender3-s1pro-2022.cfg b/config/printer-creality-ender3-s1pro-2022.cfg index 9116eb05..349fd725 100644 --- a/config/printer-creality-ender3-s1pro-2022.cfg +++ b/config/printer-creality-ender3-s1pro-2022.cfg @@ -2,8 +2,8 @@ # S1 Pro. To use this config, check the STM32 Chip on the V2.4S1 Board # then during "make menuconfig" select either the STM32F103 with a # "28KiB bootloader" or select the STM32F401 with a "64KiB bootloader" -# and serial (on USB PA10/PA9) communication for both depending on the -# STM32 Chip installed on your printers Motherboard. +# and serial (on USART1 PA10/PA9) communication for both depending on +# the STM32 chip installed on your printer's motherboard. # If you prefer a direct serial connection, in "make menuconfig" # select "Enable extra low-level configuration options" and select diff --git a/config/printer-creality-sermoonV1-2022.cfg b/config/printer-creality-sermoonV1-2022.cfg index ef100fb3..ca8a91a6 100644 --- a/config/printer-creality-sermoonV1-2022.cfg +++ b/config/printer-creality-sermoonV1-2022.cfg @@ -2,7 +2,8 @@ # with CR-FDM-v2.4.S1.200 motherboard. # To use this config, during "make menuconfig" select the STM32F401 -# with a "64KiB bootloader" and serial (on USB PA10/PA9) communication. +# with a "64KiB bootloader" and serial (on USART1 PA10/PA9) +# communication. # If you prefer a direct serial connection, in "make menuconfig" # select "Enable extra low-level configuration options" and select |